Moisture Control/Radiant Heat Statement

When receiving wood flooring the customer is to acclimate the floor to the environment. Solid flooring should receive 10 - 14 days of acclimation and then check and see if the moisture level of the floor is between 6% - 9%. That is the moisture level percent for most regions. Dry climates can go under 6% and humid climates can end up at 10% or 11%. Acclimate the floor to your conditions. When nailing down a floor to plywood the difference in moisture content between the plywood and the flooring is not to be more than 2%. This is important to prevent moisture damage to flooring. Let your engineered floor acclimate 5 - 10 days. Although in many instances homeowners take less time. Acclimation time is only considered after HVAC system has been running for a minimum or 48 hours and has established proper environment conditions in the building.

Moisture problems in wood floors can be caused by different factors. Wood absorbs or loses moisture until equilibrium with the surrounding air is reached. When the moisture content changes, shrinking, cupping or even crowning may occur.

Ambient conditions inside heated homes or offices usually range between 35% and 55% relative humidity when the temperature is 60 degrees F to 80 degrees F. Relative humidity between 35% - 55% must be maintained throughout the life of the floor.

Floor installers have to deal with different relative humidity conditions depending on when and where the installation takes place. Average relative humidity differs between coastal and inland areas and between summer and winter. This is the main reason why acclimation is an important step when installing hardwood floors.

In dry or humid climates care must be taken to maintain proper conditions to avoid increasing the tendency of natural wood to shrink, crack, swell and warp. When exposed to low humidity (below 35%) the engineered wood flooring "top layer" is susceptible to shrinkage, cracking, and delamination. Certain wood species are much more susceptible to shrinking and cracking when exposed to low humidity. Some of these species are but not limited to: Jatoba (Brazilian Cherry), Ipe (Brazilian Walnut), Santos Mahogany, Wenge, Cumaru (Brazilian Teak), Douglas Fir, Hard Maple, and Tigerwood.

Radiant Heating Floor Systems

When installing solid or engineered hardwood flooring over a radiant heat flooring system only approved floors will have a warranty. Written approval from Hurst Hardwoods or the flooring manufacturer must be given to customer at time of purchase. Radiant Heat can cause shrinking, cracking, delamination etc… to hardwood flooring and only certain solid or engineered floors are designed to handle the conditions produced from radiant heat. If your flooring purchased from Hurst Hardwoods has a warranty to be installed over radiant heat it must be stated on customers invoice.

 

 

THE DISCOUNT FLOORING CO. 

Hours of Operation:
8:00 - 4:30  (Monday - Friday)
9:00 - 1:00 (Saturday)

Toll free – 866-449-0444
Local (231) 937-6700
Fax (231) 937-5885

Address
105 Douglas Rd. E.
Oldsmar, FL 34677
 
 
 
         
NWFA


domain registration